CISCO problem: No debug on IPSEC/ISAKMP VPN setup? | [H
When the logging buffer becomes full, new logged messages overwrite old messages. Use the logging buffered command to specify the logging buffer as a destination for syslog messages, set the size of the logging buffer, and limit syslog messages sent to the logging buffer based on severity. Router#clear logging Clear logging buffer [confirm]
When you could lower the logging trap severity instead. In many cases you can safely lower the trap severity level to 5 which blocks “Debug” and “Informational” message types. See the section “The Anatomy of a Log Message” for more information on severity levels.
cisco 端口映射问题 帮忙看看那里出问题了 始终映 … 2010-3-4 · 你的192.168.20.*网段能ping通你路由器吗?你做了单臂路由就不能用主接口了,需要再配置一个子接口来连接192.168.20.*网段。你的192.168.20.*是属于哪个VLAN?是NATIVE VLAN吗?加我QQ吧,17978252,注明NAT问题,我一般晚上在线。 你把
Command. Logging Buffered. Use. This is a handy command that stores log messages so they can be reviewed later. This is especially useful when you are telneting between multiple routers as you would normally miss the console or debug messages on the router your not connected to.
Syslog | ネットワークのおべんきょしませんか?